It makes use of the package pgf used for designing and drawing with a huge tool database.
Latex sidenotes smaller font size manual#
In both versions the width of the text block stays exactly the same and thefore there is no need to re-check the typesetting result which is usually the case because despite good default typesetting quality produced by LaTeX, long documents often require additional manual tuning such as removal of widow/orphan lines or re-location of figures after switching layouts. The last command set enables easy switching between one- and two-sided versions of the document (with corresponding offset of the text block) by changing only oneside (or twoside) option of the \documentclass command. The corresponding one- and two-sided page layouts looked as follows: \documentclass. The value of DIV=14 (see corresponding table in section 2.6 of KOMA-script manual) resulted in dimensions of the text block suitable for 160 mm-wide figures: with such choice of DIV the text block was wider than any figure. In my thesis I have prepared all the figures with maximal width of 160 mm, and did not perform any scaling while including them into the LaTeX document, which was done to have similar size of the font in figures and in the text, as well as consistency in the final size of figure elements (such as thickness of lines and dimensions of markers). The typearea option DIV defines the amount of rows and columns, and a larger value results in a wider text block and narrower page margins. One of the approaches used by typearea to construct a page layout is to divide the page into equal amount of rows and columns, and then extract part of the cells from the resulting cell set (see details in section 2.2 in KOMA-script documentation).
Changing default page layout with typearea packageĪ recommended way (see section 1.2 in "An essential guide to LaTeX2ε usage") to change a page layout in LaTeX is to employ typearea package, which is part of KOMA-script bundle. It worth noting that reduction of the margin sizes also restricts the possibility of a reader to make margin notes on a hardcopy of the document. margin notes), and therefore their size could be safely reduced.
(Of course there are always aesthetic and technical limits in such size reduction.) Additionally, I did not place informational content into the page margins (e.g. An additional switching between pages will slow down this process, and therefore it is straightforward to increase the amount of information (text) displayed on a page by reducing the page margins and font size. In my thesis the text often discusses the data shown in figures, and reading the document assumes switching reader’s attention from text to figures and back. The default margins produced by LaTeX appeared to me too wide. As you see, changing the page layout from oneside to twoside leads to asymmetric horizontal margins and corresponding shift of the text block while its width is kept fixed which can be seen in the non-changed location of the last line of each paragraph.
0 kommentar(er)
